Introduction The goal of the experiment is to examine how the rate of reaction between Hydrochloric acid and Sodium thiosulphate is affected by altering the concentrations. The concentration of Sodium thiosulfate will be altered by adding deionised water and decreasing the amount of Sodium thiosulphate. Once the Sodium thiosulphate has been tested several times. The effect of concentration on the rate of reaction can be examined in this experiment. The chemical equation for this experiment is hydrochloric acid + sodium thiosulphate + deionised water (ranging from 25ml to 0ml in 5ml intervals) sodium chloride + deionised water (ranging from 25ml to 0ml in 5ml intervals) + sulphur dioxide + sulphur. As a scientific equation, this would be written out as, NA2S2O3 + 2HCL + H2O (ranging from 25ml to 0ml in …show more content…
One person may classify the cross as no longer visible if they have a poorer eyesight or slower reaction time than another person. Therefore, the dependant variable might be affected. Make sure that the person who is recording when the X is no longer visible is always the person with the best eyesight and fastest reaction time. Temperature, when substances are left in room temperature. They change from the temperature of the container (which is not always room temperature) to room temperature. This means there might be slight variation in the temperature of the substances used for the experiment. Temperature affects the rate of collision by adding or lessening the amount of kinaesthetic energy for particle collision. Thereby affecting the rate of reaction. Wait for substance to adjust to room temperature before use. Container, the container affects the surface area and the number of particles that are exposed to each other The thinner the container the slower the reaction as there are less particles which the substances can collide with. Use the same sized container for every experiment
Introduction The purpose of this Lab was to identify the density of the unidentified object and determine what substance the unidentified object given by the teacher was. The density calculated in the experiment will stay the same because the density of the unidentified object will stay constant. The Independent Variable of this experiment was the calculated density and the unidentified object given. The Dependant Variable for this experiment was the density.
Repeat steps 1-10 for two more trials. Conclusion: 1. I chose to compare temperature and amount of reactants in my experiments. I chose these because I thought they would reveal the the most drastic time differences. I also chose these factors because I had prior knowledge of them before I even started chemistry.
We were asked to correctly communicate these findings as we tested each of the substances she had encountered with both water and hexane. In experiment number three, The Relationship Between the Volume of a Gas and the Temperature, we where given a list of materials and asked to come up with our own procedure, which we did using zip lock bags filled with air, and submerged fully in a measured amount of water in order to find the volume, and then the change in volume when the temperature of the water was increased. In the fourth experiment we were asked to find the temperature of heated water, based on the cold and warm water. The experiment also required that each section be preformed several times in order to ensure accuracy, and also asked that the experimental responsibilities be split up between lab partners, each doing a section of the testing. This gave us an opportunity to work together with our fellow lab partners, with no one person doing the bulk of the work.
Identify the independent Variable Size of the tablet Identify the dependent Variable Reaction time List the controlled variables The solution (water), temperature, volume of water (200 mls) The amount of Alka- Seltzer How will the dependent variables be measured A stop watch will be started as the pieces of Alka-Seltzer are dropped into 200ml of room temperture water Describe the expected results if the hypothesis is true The 3 smaller pieces of Alka Seltzer will dissolve quicker than the ½ tablet .
Why Will The Alaskan Way Viaduct Collapse The Alaskan Way Viaduct would collapse in cause of temperature, density changes, and the layers of the Earth. The layers of the Earth are the inner core, outer core the mesosphere, asthenosphere, lithosphere, and the crust including continental and oceanic crust. In the Density Column lab we poured five different liquids into a test tube.
After obtaining an homogeneous mixture, the flask was placed in an ice bath during five minutes next to a graduated cylinder containing 5.0 mL of concentrated sulfuric acid. The temperature of the ice bath was recorded to be 1.1 °C. Likewise, a second graduated cylinder containing 1.8 mL of nitric acid and 2.5 mL of sulfuric acid was immersed in the cold ice bath to keep the three different solutions at the same temperature. Thereafter, the cold 5.0 mL of H2SO4 were added to the erlenmeyer flask containing the acetanilide solution, which remained in the cold water for approximately another 4 minutes.
The effect of pH on the speed of enzyme interaction with substrate chemicals Hypothesis: About pH: If the pH level is less than 5, then the speed of the enzyme reaction will be slower. About temperature: If the temperature stays the same, then the speed of the enzyme reaction will not be completely affected. Background information: The function of enzymes is to speed up the biochemical reaction by lowering the activation energy, they do this by colliding with the substrate.
8) Explain how each experiment type (question 7) differs from the
In this particular experiment the constant condition, the factor that was never changed, was the room temperature water. The independent variable, the variable the student affected, was how much water was placed into the beakers. The dependent variable, a variable that was affected by the independent variable, was the time it took for the tablet to fully dissolve. The control group, which did not receive treatment from the students, was the 50 ml of water as a result of being the medium between the three measurements of water. Finally, the experimental group, the subject that was exposed to the variable during the experiment, was the 25 ml and 75 ml of
Introduction: In this assignment, I will be doing two experimentations on examining the impact of temperature on the Alka-Seltzer’s response time. The first experimentation that I will be doing involves some water that is room temperature. The second experimentation that I will be doing involves some water that is very hot. If I want to be able to figure out the impact of the temperature on water, I will have to document the time it will take for the Alka-Seltzer to go into solution.
The control in the experiment is water. Units used while timing the productivity of gas from an Alka-Seltzer tablet in different temperatures is, seconds. In order to find out if temperature controls the rate of chemical reaction, whether hot water is a more effective way to make the gas produce at a faster speed, it would be necessary to compare the results of different temperatures at the end of each trial. In order to do this the scientists will measure the volume of gas that is produced within a 10 second interval time after the tablet begins to react.
Dependent The time taken for the bluish -black color to fade away (color of Iodine solution mix with starch solution ). The rate of enzyme reaction Minutes (min) Table 1.1 – Table shows the controlled variables in the experiment variables Units Measures of controlled variables.
Acids are proton donors in chemical reactions which increase the number of hydrogen ions in a solution while bases are proton acceptors in reactions which reduce the number of hydrogen ions in a solution. Therefore, an acidic solution has more hydrogen ions than a basic solution; and basic solution has more hydroxide ions than an acidic solution. Acid substances taste sour. They have a pH lower than 7 and turns blue litmus paper into red. Meanwhile, bases are slippery and taste bitter.
This experiment has to be carried out carefully
Name: Brendan Date : 24th Nov How temperature affects the rate of reaction Research Question: Does increasing or decreasing the temperature of hydrochloric acid affect the rate of reaction with magnesium? Introduction: The four factors that affect the rate of reaction; surface area, catalysts, temperature and concentration. In this case, it would be the temperature (Rate of Reaction of Magnesium with Hydrochloric Acid).