Discussion/Conclusion:
The question of the experiment was the effects of concentration, temperature, pH lever, and inhibitors of enzymes that increase the rate of a chemical reaction without making a change itself in living cells. In the experiments, peroxide was used as the enzyme. The hypotheses were:
1. Concentration of the extract would directly affect enzyme activity.
2. Rise in temperature would rise the rate of enzyme activity and absorbance until the temperature hits the optimal temperature,
3. pH level would affect enzyme activity,
4. and, the existence of inhibitor would decrease rates of the enzyme activity.
According to the figure 1, higher concentration of the enzyme extract brought higher absorbance. The slopes of the graph show
…show more content…
Enzyme with the least extract, 0.5mL, had the lowest absorption rate at the end. However, it had a higher rate than 1 ml ones until 80 seconds passed. I assume that decrease of the absorbance rate as it is fully saturated and cannot absorb more like other two controlled enzymes with larger amounts of extracts. According to the figure 2, reaction rates and concentration of enzyme extracts are directly related. As the amount of extract increases, the reaction rate also increases constantly. In conclusion, the test and figures one and two supported that the hypothesis 1 was correct: The concentration of enzyme extracts directly affects enzyme activity. According to the figure 3, absorbance keep increases no matter the temperature, but slopes are varied by the control. The coldest enzyme at 4 C had the highest absorbance, and the slope is also steeper than others. Then the observance decreases with the increase of the temperature, until 42 C. 4C is having highest, then 25C, 32C, 60C, and 42C had the lowest absorbance. The graph shows that as temperature increases absorbance decreases until 42C. Temperature affects the …show more content…
According to the figure 5, pH 5 had the highest absorbance and pH 3 had the least. pH 7 had the second highest absorption after 2 minutes of measurement. According to the graph, I assume that, absorption would decrease as pH reaches two ends of the scale. pH 3 and pH9 were two lowest pH tested in enzymes and the had lowest absorbance at the end. Enzymes with a pH level around the middle of the scale (pH6~8) had steeper graph lines than others, which means as pH level reaches to the neutral, the absorbance increases. The level of pH affects absorption of the peroxidase. According to the figure 6, closeness of pH 5 to 7 determines the enzyme’s reaction rates. It had the lowest reaction rate is at pH 3 and 9 while it had the highest at pH 5. In conclusion, the enzyme reaction rate is higher at the neutral state of pH and the pH level affects the enzyme’s activity. Therefore, I accept the hypothesis 3 which was the pH level would affect enzyme
As pH increases or decreases to get closer to the optimal pH --in this case it is 7 for this particular enzyme-- the rate of reaction peaks and is highest at that point, which is described by the molecular shape and structure of the enzyme at its optimal pH. When turnip peroxidase is at pH 7, the active site is able to fit perfectly with the substrate, therefore explaining why the reaction rate is fastest at this point. Accordingly, if the active site is disrupted, the substrate cannot fit perfectly causing the reaction rate to slow down. This can be supported by the data because the reaction rate gradually increased from pH 3 to pH 7 and reached its maximum at pH 7. Once it did reach the optimal pH, the reaction rate continuously decreased
Title: Enzymes Abstract: Enzymes can catalyze chemical reactions by speeding up the chemicals activation energy. Temperature and pH are just two of the factors that affects enzymes and their involvement with chemicals and the way they function. Throughout this experiment, we conducted a study on peroxidase, which is an enzyme. The following information consist of the recordings of when it was exposed to four different pH levels to come up with an optimum pH and IRV at the end. Introduction: Enzymes are proteins that are used in reactions in living organisms.
After record your data and determine the absolute rate of the enzyme-catalyzed reaction. Based on the data and observations the hypothesis was accepted. It was accepted because when pH were changed to a variety of levels the transmittance began to get higher reaction rates. The increased absorbance means greater amount of product and a higher reaction rate will be produced.
The purpose of this experiment was to analyze the effects of the variables: temperature, pH, and enzyme concentration, on the enzymatic reaction rate of catalase and the level at which its products are released, measuring the rate of absorption using the indicator solution guaiacol and a spectrophotometer to develop a hypothesis of the ideal conditions for these reactions. My hypothesis is that the extremes in concentration, temperature and pH will negatively affect the Au rate. This experiment used 11 solutions contained in cuvettes. Each cuvette, once mixed, is placed in spectrophotometer and then a reading taken every 20 seconds. Cuvettes 1, 8, and 10 are used as blanks to zero out the spectrophotometer.
It was hypothesized that the optimal pH for the enzyme was pH 7 while the 1.0 ml peroxidase would have the best reaction rate. At the end of the experiment the results prove the hypothesis to be incorrect. INTRODUCTION Enzymes are proteins that allow a reaction to speed up. These proteins are made up of monomers known as amino acids.
The objective of this lab was to determine the best pH level to increase enzyme activity. As this objective was met, it was discovered that water (pH level 7) was the best for percent absorbance. The hypothesis for this experiment was, “If peroxidase is an enzyme and therefore contains certain pH tolerances, then when placed in solution with pH levels of three, seven, and ten and the reaction is measured by a colorimeter, then water will be the optimal solution for maximum reaction rate.” As seen in the tables and graphs, the data supported the hypothesis due to the fact that most enzymes have an optimal pH of 4-9.
The effect of pH on the speed of enzyme interaction with substrate chemicals Hypothesis: About pH: If the pH level is less than 5, then the speed of the enzyme reaction will be slower. About temperature: If the temperature stays the same, then the speed of the enzyme reaction will not be completely affected. Background information: The function of enzymes is to speed up the biochemical reaction by lowering the activation energy, they do this by colliding with the substrate.
purpose the propose of this experiment was too see if the chemical reaction of a enzyme can be made faster. Hypothesis I think that a warm environment would be best to make an enzyme’s reaction faster. because a protein can move faster in heat.
LABORATORY REPORT Activity: Enzyme Activity Name: Natalie Banc Instructor: Elizabeth Kraske Date: 09.26.2016 Predictions 1. Sucrase will have the greatest activity at pH 6 2. Sucrase will have the greatest activity at 50 °C (122 °F) 3.
LABORATORY REPORT Activity: Enzyme Activity Name: Natalie Banc Instructor: Elizabeth Kraske Date: 09.22.2016 Predictions 1. Sucrase will have the greatest activity at pH 6 2. Sucrase will have the greatest activity at 50 °C (122 °F) 3. Sucrase activity increases with increasing sucrose concentration Materials and Methods Effect of pH on Enzyme Activity 1. Dependent Variable amount of product (glucose and fructose) produced 2.
Enzymes speed up chemical reactions enabling more products to be formed within a shorter span of time. Enzymes are fragile and easily disrupted by heat or other mild treatment. Studying the effect of temperature and substrate concentration on enzyme concentration allows better understanding of optimum conditions which enzymes can function. An example of an enzyme catalyzed reaction is enzymatic hydrolysis of an artificial substrate, o-Nitrophenylgalactoside (ONPG) used in place of lactose. Upon hydrolysis by B-galactosidase, a yellow colored compound o-Nitrophenol (ONP) is formed.
Introduction: Enzymes are biological catalysts that increase the rate of a reaction without being chemically changed. Enzymes are globular proteins that contain an active site. A specific substrate binds to the active site of the enzyme chemically and structurally (4). Enzymes also increase the rate of a reaction by decreasing the activation energy for that reaction which is the minimum energy required for the reaction to take place (3). Multiple factors affect the activity of an enzyme (1).
Introduction In class, a series of experiments were performed that pertained to the enzyme known as catalase, which converts hydrogen peroxide into oxygen. Due to peroxide being toxic to the tissues of both plants and animals, both possess the enzyme catalase, which breaks into two non-toxic compounds: water and oxygen gas. Enzymes are proteins that react to certain substrates to create a product, and continue doing so afterwards. Methods and Materials To test reactions between catalase and hydrogen peroxide, groups of three to four people were formed.
5 water bath were set up each to10 °C. (5 were used do the experiment faster) 5 cm3 of starch solution were added into the 5 test tubes that were labeled test tubes. Then 5 cm3 of amylase enzyme was added into the other 5 test tubes that were labeled. Put one of the starch solution test tube (preferably the one labeled 1) and one of the test tube containing amylase into the water bath (10 °C).
ABSTRACT: The purpose of the experiments for week 5 and week 6 support each other in the further understanding of enzyme reactions. During week 5, the effects of a substrate and enzyme concentration on enzyme reaction rate was observed. Week 6, the effects of temperature and inhibitor on a reaction rate were monitored. For testing the effects of concentrations, we needed to use the table that was used in week 3, Cells.